It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
El manual esta muy detallado, los numeros de partes y los esquemas de despiece son correctísimos y muy claros, tanto para los técnicos experimentados como para los novatos.
4.9.3 Adjustment Procedure
TOP PREVIOUS NEXT 1. Input an NTSC monoscope pattern signal and check that the picture locks horizontally. 2. Set the SCAN switch to over-scanning mode (original size). 3. Set the monitor to the FACTORY mode and select DISPLAY REF from the menu. 4. Adjust H POSI and V POSI on the DISPLAY REF menu to position the center of the picture at the center on the front of the picture tube. 5. Adjust H SIZE and V SIZE on the DISPLAY REF menu to obtain a horizontal scale of 2.5±0.3 and a vertical scale of 2.0±0.3 as a screen size. 6. Set the SCAN switch to under-scanning mode and check that the picture is fully displayed. 7. Set the ASPECT switch to the 16:9 mode and check that the vertical screen size is 175 mm±8 mm. 8. Set the SCAN switch to over-scanning mode (original size) and change the input signal to a PAL Philips pattern signal. 9. Set the ASPECT switch to the 4:3 mode and check that the center of the picture is positioned at the center on the front of the picture tube. 10. Set the SCAN switch to under-scanning mode and check that the picture is fully displayed. 11. Set the ASPECT/ switch to the 16:9 mode and check that the vertical screen size is 175 mm±8 mm. �@ TOP PREVIOUS NEXT