|
|
|
Who's Online
There currently are 5809 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hi
First, thank you very much for the fast delivery.
I'm really satisfied with your manual. I could find everything, I needed.
I appreciate your service.
Regards from Germany PB
;
Everything you need: schematic, circuit explanation, operating/testing instructions. Awesome.
 ;
Correct and accurate service manual for that Siemens (Nordmende) TV. Price is worthwhile as the Manual is fully usable.
;
Just what I needed to repair my CT-F600, clear pdf, easy to tread and navigate
;
Yes, cost is low. And quality of some diagrams is low too.
4.1. About lead free solder (PbF)
Distinction of PbF P.C.B.: P.C.B.s (manufactured) using lead free solder will have a PbF stamp on the P.C.B.
Caution:
- Pb free solder has a higher melting point than standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please use a high temperature soldering iron. In case of the soldering iron with temperature control,please set it to 700 ± 20°F (370 ± 10°C). - Pb free solder will tend to splash when heated too high (about 1100°F/600°C). - When soldering or unsoldering, please completely remove all of the solder on the pins or solder area, and be sure to heat the soldering points with the Pb free solder until it melts enough.
5. Each Buttons 6. Taking out the Disc from RAM-Drive Unit when the Disc cannot be ejected by OPEN/CLOSE button
6.1. Forcible Disc Eject
6.1.1. When the power can be turned off.
1. Turn off the power and press [STOP] [CH UP] keys on the front panel simultaneously for 5 seconds.
6.1.2. When the power can not be turned off.
1. Press [POWER] key on the front panel for over 10 seconds to turn off the power forcibly, and press [STOP] [CH UP] keys on the front panel simultaneously for 5 seconds. 6.2. When the Forcible Disc Eject can not be done. 1. Turn off the power and pull out AC cord. 2. Remove the Top Case. 3. Remove the Front Panel. 4. Remove 4 screws and Upper Base Unit from DVD-RAM Drive. 5. Take out the disc and put the Opener Roller on fully position for
6
|
|
|
> |
|
