|
|
|
Who's Online
There currently are 5853 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great scan but please note that it is entirely in GERMAN.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
EH2511W_OI_EU4.qxd 05.9.6 8:19 ��� 6
Caution during use
When mist is not released, follow the steps below to clean the appliance. (Fig. 7)
1. Turn the Power Switch off and insert the pointed end (remove the cap) of the Cleaning Tool (F ) into the Mist Nozzle for a a few times. 2. Fill the Water Tank with water. 3. When both the Mist Switch and Power Switch are turned on, block the Mist Nozzle with the pointed end of the Cleaning Tool for approximately 10 seconds (while checking to see if the water in the tank is bubbling). - A cotton swab (F ) may be b used instead of the Cleaning Tool. 4. Drain the water out of the Water Tank. � If the mist is not released, repeat steps 1-4. If the mist is still not released after repeating steps 1-4, take the appliance to your dealer for service. � Water droplets may sometimes be found on the appliance. This is the water that has remained after inspection and is sanitary.
1. Put some water (warm if you like) in a washbowl. � Do not use hot water � Do not use detergent 2. Remove the suction cup, soak the Suction Hole (Filter) in the water, and turn the Power Switch on to wash for about 15 seconds. 3. Remove the appliance from the water. Then, leaving the appliance switched on for about 30 seconds to allow water to drain from the main body, shake the water off. 4. Empty the Water Tank and allow it to dry by leaving the Cap unplugged. 5. Wipe the body of the appliance and the reversible cups with tissues or cotton buds, taking particular care to thoroughly wipe the insides of the suction cup.
For environmental protection and recycling of materials
This pore cleanser contains NickelMetal Hydride (Ni-MH) battery. Please make sure that the battery is disposed of at an officially assigned location if there is one in your country.
Caution
� Pull out the plug of the Charger when not in use. Always grasp the plug while unplugging and never unplug by pulling the cord. � Do not cut, damage, or modify the cord. Do not pull, twist, or bend the cord with unnecessary force. Do not place heavy objects on the cord or allow the cord to get pinched in between objects. Do not wind the cord around the appliance. � The supply cord of this appliance can not be replaced; if the cord is damaged, the appliance should be discarded. � Do not use the appliance near inflammable materials, such as benzine, paint thinner, sprays, etc. � Do not use this appliance with a damaged or broken cup, since injury may be occurred. � When using the appliance, take care to use it only on the nose. Do not stop at any one point on the skin. � Do not use the appliance on pimples, blemishes, sunburned or broken skin or any skin inflammations. � Do not pass the appliance over the same point more than three times if you have sensitive skin. � Never touch the Charger plug while your hands are wet. � Do not place or store the Charger near water. � Never reach for Charger that has fallen into water. Unplug immediately.
How to remove the built-in rechargeable battery before disposal of the pore cleanser
(Fig. 10) The battery in this pore cleanser is not intended to be replaced by consumers. However, the battery may be replaced at an authorized service center. The procedure described below is intended only for removal of the rechargeable battery for the purpose of proper disposal. Always make sure that the battery have been removed from the pore cleanser before disposing of it. 1. Unscrew the screw and remove the battery cover. 2. Unlatch the hooks on either side and pull out from the body of the appliance. 3. Cut the red and black lead wires on either side and further pull out from the body of the appliance. 4. Insert a flat-head screwdriver into the slot (F ) and lift up the a Ni-MH battery. 5. Remove the Ni-MH battery.
Regular maintenance
(Fig. 9) � Suction Hole (Filter) and Mist Nozzle Turn the Power Switch off and remove any accumulated dirt using the Cleaning Tool provided. � Charger Clean the Charger using a cloth and soapy water, then dry thoroughly before resuming use. � Do not use detergent to avoid the risk of discolouration, deterioration, or cracking.
Cleaning
After using the appliance
(Fig. 8) � Both the body of the appliance and the cups can be washed using water. 6
7
|
|
|
> |
|
