|
Who's Online
There currently are 5910 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
EU6441-U1
5. Grease on the Screw of the Seat unit. a. Grease the Screw from the bottom to the top. Be careful not to splash grease on other parts. b. Turn on the Power switch. c. Push the Controller case and operate the Seat unit.
6 CHECK THE OPERATION
1. Push the On/off button on the Controller and select the Programmed course. (Select other than the Exercise course.) Caution: Be careful not to hurt your fingers because the Seat angle becomes parallel right when the course is selected. 2. Point of checking · It operates with the R-shape of the Power source wire and the Sensor wire on A part unchanged. · Nothing hits the Motor or the Transformer. · When the Seat unit operates, nothing hooks or deforms the Sensor plates or deforms.
7 INSTALL THE SAFETY COVER AND MACHINE COVER
1. Install the Machine cover. 2. Install the Safety cover. *When installing, proceed the reverse procedures of disassembly.
8 FINAL OPERATION CHECKING
1. Select the Programmed course pushing on the On/off button of the Controller. (Select other than the Exercise course.) 2. Checking points · All the Rivets on the Safety cover are installed? (Front- three, Left/right- six, Back-four) · Any irregular noise in the operation? If so, check the alignment of Wires again. · When you stop the machine in leaning forward or backward, does the angle of the Seat go back to the parallel automatically?
16
|
|
|
> |
|