Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
Text excerpt from page 15 (click to view)
Before you call for service...
Troubleshooting Tips Save time and money! Review the chart below first and you may not need to call for service.
Normal Operation
� You may hear a pinging noise caused by water being picked up and thrown against the condenser on rainy days or when the humidity is high. This design feature helps remove moisture and improve efficiency. � You may hear the relay click when the compressor cycles on and off. � Water will collect in the base pan during high humidity or on rainy days. The water may overflow and drip from the outdoor side of the unit. � The fan may run even when the compressor does not.
Abnormal Operation
Problem Possible Causes I The air conditioner is unplugged.
Air conditioner does not start
What To Do � Make sure the air conditioner plug is pushed completely into the outlet. � Check the house fuse/circuit breaker box and replace the fuse or reset the breaker. � When power is restored, wait 3 minutes to restart the air conditioner to prevent tripping of the compressor overload. � Make sure there are no curtains, blinds, or furniture blocking the front of the air conditioner. � Set the TEMP Control to a lower number.
I The fuse is blown/circuit breaker is tripped. I Power failure.
I Airflow is restricted. I TEMP Control set to a higher number.
Air conditioner does not cool as it should
Before you call for service...
I The air filter is dirty. I The room may have been hot. I Cold air is escaping.
� Clean the filter at least every 2 weeks. See the operating instructions section. � When the air conditioner is first turned on you need to allow time for the room to cool down. � Check for open furnace floor registers and cold air returns. � Set the air conditioner's vent to the closed position. � See Air Conditioner Freezing Up below. � Set the mode control at High Fan or High Cool with the high temperature.
I Cooling coils have iced up.
Air conditioner freezing up
I Ice blocks the air flow and stops the air conditioner from cooling the room.
