|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
helpful manual.good service.Quick response.will use again
 ;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
Making Calls
To put a call on hold
Press (HOLD/INTERCOM/CLEAR) twice.
�The IN USE/HOLD indicator light �ashes, �Hold� is displayed and the call is put on hold. �To transfer the call to another handset, see page 44. �If a call is kept holding for 6 minutes, an alarm tone will start to sound. After 4 additional minutes on hold the call will be disconnected. �When you put the call on hold, �Line on hold� is shown on the display of other handsets.
Hold
[1]
To release the hold
Press or .
�Another handset user can also release the hold by pressing or . �If another phone is connected on the same line (p. 60), you can also release the hold by lifting its handset.
To adjust the receiver volume (HIGH, MEDIUM or LOW) or speaker volume (6 levels) while talking
To increase, press �. To decrease, press �.
�Each time you press � or �, the volume level will change. �The number of steps indicates the volume level. �The display will return to the length of the call. Ex. Receiver volume: High Speaker volume: Level 6
Loud Low
GF
High
Lighted handset keypad
The handset dialing buttons will light when you press a button, lift the handset off the base unit or the charger, or when a call is received. The lights will go out a few seconds after pressing a button, lifting the handset, answering a call, hanging up a call, leaving the programming mode or ending the intercom.
Backlit LCD display
The lighted handset display will stay on for a few seconds after pressing a handset button, lifting the handset off the base unit or the charger, hanging up a call, leaving the programming mode or ending the intercom.
28
|
|
|
> |
|
