|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
;
This comprehesive service maual was greatly appreciated, as was the digital download.
;
Good en helpfull black and white scanned Srfvice manual of the Philps D8444. Quick service and delivery
;
Scan was really good quality, easy to read, download easy
;
very good manual as always. easy to read, detailed and includes schematic
MC-V5241-00
5. Pull or pry out the agitator pulley and agitator holder. 5. Rotate the agitator assembly by hand to insure nothing rubs and to check for correct assembly. 6. Replace the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section.
3.4.
BRUSH REPLACEMENT
1. The agitator brushes should be replaced when the brushes are worn. Brushes should be checked by holding a card across the lower plate. If the bristles on the agitator assembly do not touch the card you should replace all the brushes for best cleaning results.
6. Push each brush out of the agitator.
3.4.1.
Removal
1. Remove the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section. 2. Remove the agitator assembly as outlined in the AGITATOR ASSEMBLY REMOVAL/INSTALLATION section. 3. The agitator assembly may now be dissassembled and the brushes replaced. 4. Carefully remove the E-clip from the agitator shaft, do not misplace. Remove the right brush support. Pull the agitator shaft out of the opposite end of the agitator.
3.5.
3.5.1.
NOZZLE HOUSING and NOZZLE REPLACEMENT
Removal
1. Remove the lower plate, agitator assembly, and belt as outlined in their respective sections. 2. Remove the nozzle hose by pulling up on the hose supporter to remove it from the nozzle housing. Pull the nozzle hose out of main body and remove from vacuum. 3. Remove the headlight assembly and reflector by following the instructions relating to the removal of these items. 4. Remove three (3) screws from pedal assembly. 5. Insert a flat blade screwdriver between the nozzle housing 11
|
|
|
> |
|