|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
EXPLODED VIEW (BODY)...
C BLOCK
NOZZLE HOUSING AND NOZZLE HOSE REPLACEMENT
Removal 1. Remove the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section. 2. Remove the belt and agitator assembly as outlined in the respective sections. 3. Remove the nozzle hose, for nozzle hose replacement by pulling it up out of the nozzle housing and then pulling it, while twisting, out of the tool holder. 4. Remove the headlight assembly and slider support by following the instructions relating to the removal of these items. Pull the headlight wires from the grooves in the nozzle housing. 5. Insert a flat blade screwdriver between the nozzle housing and the plastic shaft, pry out the plastic shaft as illustrated, (Fig. 8). 6. Remove the nozzle housing as illustrated, (Fig 9).
(Fig. 8)
C-7
C-22 C-3
C-1
C-2
C-5
C-6
C-15 C-16 C-18
7. Remove the handle release assembly and furniture guard, (Fig 10). 8. Remove the light cover and window, (Fig. 10) by removing the two (2) screws from the nozzle housing and pushing out on the light cover while depressing the tab that secures it to the nozzle housing. NOTE: If the motor case cover is removed, DO NOT turn vacuum over as the motor may fall out. Installation
C-21
C-24 C-23
C-14 C-12 C-10 C-13 C-11 C-9
(Fig. 9)
1. Install the window, light cover, handle release assembly, and furniture guard in the new nozzle housing, (Fig. 10). 2. Fit the nozzle from the motor shaft side first, and rotate it into place on the dust container as illustrated, (Fig. 11).
C-12
C-13
C-10
3. Slide the plastic shaft through the nozzle housing and into the dust container. Make sure that the slot on the bottom of the plastic shaft is down and fitted onto the projection. Place the headlight wires back into their grooves, (Fig. 12). 4. Install the slider support. Install the headlight assembly by following the assembly instructions.
(Fig. 10)
C-20
5. Reassemble the nozzle hose by inserting it into the tool holder then place the other end into the nozzle housing with the tab fitting into the slot.
C-17 C-8 C-19
6. Install the belt, agitator assembly, and the lower plate according to the respective instructions.
C-4
(Fig. 11)
(Fig. 12)
-8-
- 17 -
|
|
|
> |
|