|
|
|
Who's Online
There currently are 5962 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Was very fast and accurate service. Just what I needed. I recommend to everyone.
 ;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
5. Remove headlight assembly. 6. Carefully turn vacuum over. Remove motor case by removing four (4) screws. 7. Lift up on the nozzle housing, plastic shaft side first.
7. 8. 9. 10. 11.
Install new brushes by reversing procedure. Reinstall agitator holder and agitator pulley completely. Reinstall the agitator shaft, end cap and E-clip. Position belt over agitator pulley on the agitator. Reinstall agitator and lower plate.
8. The nozzle housing can now be easily rotated from the motor shaft. NOTE: If the motor case cover is removed, DO NOT turn vacuum over as the motor may fall out.
3.5.
3.5.1.
Nozzle Housing Replacement
Removal
3.5.2.
Installation
1. Remove the lower plate as outlined in the LOWER PLATE REMOVAL/INSTALLATION section. 2. Remove agitator assembly as outlined in the respective sections. 3. Remove upper body by removing four (4) screws.
1. Fit the nozzle from the motor shaft side first, and rotate it into place on the dust container as illustrated.
4. Remove nozzle hose from upper body.
2. Slide the plastic shaft through the nozzle housing and into the dust container. Make sure that the slot on the bottom of the plastic shaft is down and fitted onto the projection. Place the headlight wires back into their grooves. 3. Re-install the motor case. Be carefull not to over tighten the four (4) motor case screws. 4. Carefully turn vacuum cleaner over. 5. Install the headlight, belt, agitator assembly, and the lower plate according to the respective instructions. NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or electrical enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
13
|
|
|
> |
|
