|
Who's Online
There currently are 5799 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
;
Great copy of the manual, has all information required for servicing,
4. Remove the 4 screws holding magnetron. 5. Remove 2 screws holding thermal cutout. 6. Remove the mounting bracket from magnetron and install it on the new magnetron.
Lower magnetron
1. Discharge electric charge remaining on the high voltage capacitors. 2. Remove the entire rear panel by removing screws as shown. 3. Carefully place the unit on its left side (H.V.Capacitor side). 4. Remove the cover by removing 2 screws. 5. Remove the 4 screws holding magnetron by inserting screwdriver through the 4 openings on bottom plate. 6. Remove 2 screws holding thermal cutout. 7. Remove the mounting bracket from magnetron and install it on the new magnetron.
NOTE: To prevent microwave leakage, tighten mounting screws properly making sure there is no gap between the waveguide and the magnetron.
CAUTION When connecting 2 filament lead wires to the magnetron terminals, be sure to connect the lead wires in the correct position. The lead wire with blue connector should be connected to �FA terminal� and white or pink one should be connected to �F terminal�.
16
|
|
|
> |
|