The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
Very fast, clear and usefull site !
Also this Service Manual are very well maked and with a very good definition !
Very fast download speed !
Recomended Seller !
a. Focus Adjustment
1) Confirm that each of the pixels in the nine portions are clearly visible.
b. Mechanical Picture Position Adjustment (Tilt)
1) Loosen the 4 Screws on the Projection Unit.
Screw
OPT HPOS 0024
Screw Screw Twist Twist
Screw
<MMD-CHK 2/8>
2) If not, loosen the Knob on the Projection Lens until the Knob can be moved.
<Front View>
Fig. M1-5 2) Adjust the Projection Lens by twisting so that the long line "g" and the long line "h" are within 4 dots. (The long line "g" and the long line "h" will be almost aligned horizontally.)
Tighten Knob
OPT
HPOS
0024
Loosen
Up
"G"
<MMD-CHK 2/8>
"H"
long line "g"
long line "h"
Down
"G"
within 4 dots
"H"
<Front View>
Fig. M1-6 3) Adjust the Knob by moving up or down so that each of the pixels in the nine portions is clearly visible to obtain the best focus. 4) Tighten the Knob.
Note: If the Projection Lens is twisted left, the Focus Screen twists left. If the Projection Lens is twisted right, the Focus Screen twists right. 3) Tighten the 4 Screws while fixing the Projection Lens.