Very easy to get, fast delivery. Was very helpful to solve my problem.
Text excerpt from page 10 (click to view)
Turning the power for home theatre system devices on and off at once
You can use the projector�s remote control to turn the power on and off for home theatre system devices that have been recorded in the remote control.
4
Select the device to be registered.
Note: B At the time of purchase, a macro for turning the power on and off for PJ, DVD, VCR and AMP all at once is set.
(Example: When �USER3� is selected) � If a registered device is selected, the display will flash faster.
I Using the macro function
Press and hold [SYSTEM] for 3 seconds or more.
The power for the registered devices will turn on.
� The length of time required for the macro function to finish operating effectively will vary depending on the number of devices that have been recorded.
5
Press [SYSTEM].
(Example: When �USER3� is selected) � If a registered device is selected, the display will flash faster. � To register or delete another device, repeat steps 4 and 5.
I Setting the macro function
Note: B If the distance that the projector�s remote control has to operate is too far, or if the remove control receiver of the home theatre system devices are obstructed, this operation may not work correctly. Check the locations and directions of the home theatre system devices to make sure that they can all be operated.
Clearing the macro function
Press [SYSTEM] once more.
1 2 3
Press [SETUP] for 3 seconds or more.
� The macro function will be cleared and the display will flash more slowly.
6
Select �USER 1-3� and then press [ENTER].
(Example: When �USER1� is selected)
When you have finished selecting devices, press [ENTER].
Select �MACRO?� and then press [ENTER].
To finish, press [SETUP], and then check operation.
� The display will show the devices that have been recorded by the macro.
