|
Who's Online
There currently are 5972 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
It was very usefull, it is clear the quality is super, the price I paid is very afordable.
Generally speaking Iam very happy with this company.
;
The manual was exactly what I needed, Good quality scans too. superb.
;
I am so happy found this site as it consists of so many Manuls and easy to aquire. This onei s exactly what I wanted and much more as it has info on not only how to use the tuner but how to repair it as well. I will come here 1st before purchasing else where! Thanks owner-manual.com!
;
Top class product, I printed it out on A3 paper and it is clear and very easy to follow.
Cheaper than buying a new radio!
;
is part of the manual is very useful for repairing
Here are circuit diagrams
if there is damage, I recommend using this part of the
a complete list of circuit boards and components
PV-V4525S / PV-V4535S-K / PV-455S-K
5.1.1.1.
Notes in chart
1. Installation of Top Panel Install the Top Panel front portion at a downward angle so that the tab on the Front Panel Ass�y fits into the hole in the Top Panel. Then, lower the rear portion into place and tighten 4 Screws (501, 502). 2. Installation of Front Panel Ass�y CAUTION: Opener Lever may be damaged when Front Panel Ass�y is installed, with Cassette Door-Lid of Front Panel Ass�y and Opener Lever of Cassette Up Ass�y set incorrectly. a. When installing the Front Panel Ass�y, swing the Cassette Door-Lid all the way open until the Cassette Door tab clears the Opener Lever. b. Make sure that all locking tabs are aligned properly. Then, press the Front Panel straight in.
Fig. D4
b. Make sure the phase hole of the Main Cam Gear on the bottom side of Mechanism Unit is in EJECT position.
Fig. D5
c. Install the Mechanism Chassis straight onto the Main C.B.A. so that the Photo Transistor Unit (712) clears the hole in the Mechanism Chassis and that 3 Connectors (P5002, P4001, P6201) are aligned and seated securely.
5.2.
MECHANISM SECTION
Refer to the Service Manual for R4-Mechanism Chassis for PVModel (Order No. MKE0401000C1).
Fig. D3
3. Installation of Mechanism Chassis and Cassette Up Ass�y onto Main C.B.A. a. Make sure the Mode Select SW. on the Main C.B.A. is in EJECT position. If not, rotate the Mode Select SW. until the alignment projection is in the EJECT Position.
14
|
|
|
> |
|