Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 11 (click to view)
Supplying Power
Charge the Battery Pack on the AC Adaptor
Before Use
1Connect
POWER Lamp
2Attach
and plug in the Power Cord as shown. � POWER Lamp will light. � Remove the DC Cable, if attached, from the adaptor. the Battery as shown to charge. � CHARGE Lamp lights up. It goes out when charging is complete (approx. 1 hour). Expect approx. 1 hour 50 minutes of operation (using EVF) when fully charged. the Battery. Slide the Battery out and then lift up.
CHARGE Lamp
3Remove
Note About the Flashing of the CHARGE Lamp
� Charge the Battery within an ambient temperature range of 10 °C (50 °F) and 30 °C (86 °F). � If charging is done in extreme low or high temperatures, Battery charge time increases. CHARGE Lamp flashes when... � The Battery is being charged, but charging is taking longer than normal. � Charging is not possible. Remove the Battery once, wait a short time, then re-attach it for charging.
Insert the Battery Pack
Remove the Battery Pack
1 3 2 1 2
BATT RELEASE
1
Insert the Battery Pack and slide it up until it locks with a click.
1 2
Tilt Viewfinder upward. Remove the Battery Pack and slide the Battery downward while sliding the BATT RELEASE.