|
Who's Online
There currently are 5785 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Before Using Setup on the Camcorder Using the Battery
Before use, fully charge the Battery. � We recommend using a Panasonic Battery. � We cannot guarantee the quality of this Camcorder when batteries from other companies are used.
Set [ REMOTE] on the [ SETUP] Sub-Menu to the desired Remote Control Mode. (pp. 22, 23)
Setup on the Remote Control
2 1
1 2
Attach the Battery to the AC Adaptor and charge it.
[VCR1]: Press the [Î�â�º] Button and [ â� ] Button simultaneously. 1 [VCR2]: Press the [â��Î�] Button and [ â� ] Button simultaneously. 2 â�¢ When the battery in the Remote Control is replaced, the mode is automatically reset to [VCR1] Mode.
Put the Battery on the Battery Mount by aligning the mark, and then securely plug it in.
Power Supply
Using the AC Adaptor
� Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it from the AC Adaptor. � The [CHARGE] Lamp lights up, and charging starts. � When the [CHARGE] Lamp goes off, charging is completed. � When the battery is completely discharged, the [CHARGE] Lamp blinks at first, but the battery is charged normally. When the temperature of the battery is too high or low, the [CHARGE] Lamp blinks and the charging time becomes longer than usual.
3 1 2 3
Connect the DC Cable to the Camcorder. Connect the AC Cable to the AC Adaptor and the AC Jack.
Attach the charged Battery to the Camcorder.
Connect the DC Cable to the AC Adaptor.
� Before connecting or disconnecting the power supply, set the [OFF/ON] Switch 28 on the Camcorder to [OFF] and make sure that [POWER] Lamp 32 is not lit. (p. 18)
Set the [OFF/ON] Switch 28 to [OFF], and while sliding the [BATTERY RELEASE] Switch 39 , remove the Battery downward or DC Cable. � When attaching or removing Battery, set the [OFF/ON] Switch to [OFF] and make sure the [POWER] Lamp is not lit.
28
Disconnecting the Power Source
39
� Hold down the battery with your hand so it does not fall. � For other notes concerning this item, see page 59.
15
|
|
|
> |
|