There are currently no product reviews.
muy buen manual por lo completo de este algunos esquemas estan muy divididos lo que hace algo dificil el seguimiento.
very good manual, with detail and clarity in esquematic diagrams and waveforms .
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
manual excelente completo , diagramas y esquemas bien presentados y buena calidad de imagen.
Main Cam Gear and Drive Rack Arm
1. 2. 3. 4. Remove the Main Cam Push Nut. (Refer to Note.) Pull up on the Main Cam Gear. Turn the Drive Rack Arm fully counterclockwise as shown. Pull up on the Drive Rack Arm.
1. Alignment of Main Cam Gear and Drive Rack Arm 1) Install the Drive Rack Arm so that the hole (A) is aligned with the hole on chassis as shown (Through hole (A)). 2) Install the Main Cam Gear so that the 2 holes (B) marked "E" are aligned with the hole on chassis as shown (Through hole (B)). ("E" indicates the EJECT position.)
Chassis Hole 7 Main Cam Gear 8 Drive Rack Arm turn Main Cam Gear Chassis Hole
mark Chassis Through Holes (B)
Drive Rack Arm Through Hole (A)
Main Cam Push Nut
Fig. J5-1 Note: When removing the Main Cam Push Nut, use a screwdriver etc. Shaft of Main Cam Gear Main Cam Push Nut Bottom of Chassis
2. Installation of Main Cam Gear and Main Cam Push Nut 1) Position the chassis upside down placing a Support under the Main Cam Gear. Install the Main Cam Push Nut with Needlenose Pliers etc. so that it is flush with the chassis. There may be some slight scratches on the Shaft of Main Cam Gear, when removing the Main Cam Gear. In case that the Main Cam Gear can be installed securely without tottering, it is fine to use the one. If any tottering, replace a new one.
Press Needlenose Pliers Shaft of Main Cam Gear
Bottom of Chassis
Main Cam Push Nut Main Cam Gear
Main Cam Gear support Fig. J5-2 Fig. J5-4 3. Main Cam Push Nut is not reusable. If removed, install a new one.