|
|
|
Who's Online
There currently are 5624 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
� Front and surround speaker height
(Assembled diagram) Speaker You can adjust within this range.
4
Connect the speaker cables.
Rear speaker panel
1 Twist off the vinyl ends of the speaker cables.
704 mm 1,160 mm 750 mm Pipe 818 mm Base Attach to lower rear of speaker. Attach to upper rear of speaker. 575 mm Stopper screw Do not remove.
Insert the wire fully.
_: Copper `: Silver
Push!
2 Press the speaker cable into the groove.
3
Adjust the speaker height.
If there is any excess speaker cable, detach the rubber cap on the top of the pipe and thread the speaker cable into the opening while pulling the speaker cable from the bottom of the base.
�Check the screws you tightened on page 4. e.g. Attaching the stand to the lower rear of the speaker 1 Loosen the attached speaker mounting plate screw until the attached speaker is slightly loose and adjustable. Be careful not to loosen the screw too much or the speaker may detach and fall.
2 With one hand on the base, and the other holding the speaker, adjust the height of the speaker up and down. �After adjusting the height, tighten the screw on the mounting plate securely.
5
Fasten the speaker cable to the base.
2 Fit the speaker cable into the base cover groove as far as possible.
1 Press the speaker cable and thread between the hooks. Phillips-head screwdriver Stopper screw Screw to stop mounting plate from moving or sliding below this point. Rear side of base
Cable
For your reference You can enjoy good acoustics by adjusting the height of the speaker with the height of the television so the center positions of both are approximately the same.
� Preventing the speakers from falling over (Front and surround speakers)
Preparation Attach screw eyes (not included) to secure the speakers to the wall (�diagram right). �You will need to obtain the appropriate screw eyes to match the walls and pillars to which the screw eyes are going to be fastened. �Consult with a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers. 1 Thread the string (not included) through the slot on the rear of the speaker to prevent it from falling over. 2 Loop the string through the screw eye and tie tightly. e.g. Screw eye (not included) String (not included) Wall
Approx. 150 mm
Rear of the speaker
RQT7429
5
Front and surround speaker assembly
|
|
|
> |
|
