|
|
|
Who's Online
There currently are 5953 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual is complete with excellent quality! One suggestion, show number of pages and weather it is multi-lingual. The AD 600 Manuel is about 76 pages and over half is non English. This results in a larger print job than usually needed. Having this information, one could select the desired pages for printing.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
Chapter 4 Adjustments and settings for recording
4-1-2 Adjusting the black balance
The black balance needs to be adjusted in the following cases: � When the unit is used for the first time � When the unit is used after it has not been used for a prolonged period of time � When the unit is used in an ambient temperature which has fluctuated significantly � When the value selected for the gain switch has been changed � When the super gain setting has been performed using the USER MAIN, USER1 or USER2 button � When the gamma ON/OFF setting has been changed <Notes> � Check that the lens connector has been connected and that the lens aperture is set to CLOSE. � While the black balance is being adjusted, the aperture is automatically set to the light-shielding status. � While the black balance is being adjusted, the gain selector circuit is switched automatically. Flicker or noise may appear on the viewfinder screen, but this is not indicative of malfunctioning. � If the black shading is still unsatisfactory although the �ABB OK� message is displayed, perform menu operations to open the <BLACK SHADING> screen from the MAINTENANCE page, move the arrow mark (>) to the DETECTION item, press the JOG dial button, and proceed with the black shading adjustment. If the ABB switch is held down for 5 or more seconds, the black shading can be automatically adjusted after the ABB operation. (See the SHD.ABB SW CTL item under �7-5-5 SW MODE.�) � If the AUTO W/B BAL switch is pushed down to the ABB position again while the black balance is being automatically adjusted (ABB ACTIVE), the adjustment will be aborted. The adjusted value in this case is the value before automatic adjustment was performed.
4
1
Set the switches as shown in the figure.
Black balance memory The values stored in the memory are retained even after the unit�s power has been turned off.
AUTO W/B BAL switch: Use this to execute ABB. OUTPUT: CAM
2
Set the AUTO W/B BAL switch to the ABB position, and then release it. The switch returns to the center, and the adjustment is performed. While the adjustment is in progress, the following message appears on the viewfinder screen.
ABATV B CIE
3
<Note> While the adjustment is in progress, the lens aperture is automatically set to CLOSE.
4
Adjustment is completed in several seconds. (A message similar to the one shown in the figure below now appears.) The adjustment value is automatically saved in the memory.
ABO B K
29
|
|
|
> |
|
