|
Who's Online
There currently are 6041 guests and 2 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
thanks for this download i got a pioneer bdp-lx70a blu-ray player and it had no manual i search everywhere on the internet and came across owner-manuals.com and i found that it was so easy to find and downloaded from this site if i ever need a manual again this would be the first place that i would come too thanks guys
;
Superb! It's the original manual. We can now use our old calculator with its full function.
;
This is a very well written and comprehensive manual. It answered all our queries.
;
Excellent copy that was delivered within 12 hours and solved my problem.
;
I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
Power Supply
ª Using AC Adaptor 1 Connect the AC Main Lead to the AC Adaptor and the AC
DC IN 4.8V
1 2
main socket. 2 Connect the DC Input Lead to the [DC IN 4.8V] socket on the SD Multi AV Device. THE SOCKET OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.
Using the Battery
ª Using the Battery 1 While holding the [
1
] part, slide it to remove the Battery Compartment Cover. 2 Press the terminals of the battery onto the terminals of the Battery Compartment and set the battery.
�Fit the battery with its label facing upward. �After the battery is set, close the cover.
3 Connect the AC Main Lead to the AC Adaptor and the AC
Main socket. 4 Connect the DC Input Lead to the [DC IN 4.8V] socket on the SD Multi AV Device.
� Power Lamp flashes, and Charging starts.
2
5 Wait until Power Lamp 1 goes off.
�When recharging is completed, Power Lamp goes off. �Disconnect the DC Input Lead and hold down the [ ] button for two seconds or more, and the SD Multi AV Device is turned ON.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer�s instructions.
DC IN 4.8V
1
3 4
Removing the Battery
�When the Battery Level Indicator indicates [ ], the battery will run out in a few minutes. Recharge the battery. �It takes about 120 minutes, maximum for full-charging. (The charging times are for normal ambient temperature (68F°(20° C) /60%). If the Battery is charged at a higher or lower temperature, the charging time may be longer) �When recharging, turn the power of the SD Multi AV Device OFF. �If the Power Lamp flashes quickly (or slowly) when recharging, recharging is not normal. (l 35) �When the battery is running out while the SD Multi AV Device is being used, the Power Lamp starts to flash. Recharge the battery or use the SD Multi AV Device with the DC Input Lead connected. �If you disconnect the DC Input Lead or the AC Main Lead while charging the Battery, Power Lamp flashes several times and goes off. For continuing Battery charge, wait for about 1 minute, and then connect the AC Main Lead and the DC Input Lead.
6
|
|
|
> |
|