Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Text excerpt from page 28 (click to view)
INSTALLATIONS
Rack Mounting
The encoder and the decoder can be installed in the following racks. � Racks equivalent to EIA standard: Type 19" EIA standard (depth: more than 450 mm (17-11/16"))
Blank panel (1U)
This unit
A device that generates heat such as a power amplifier This unit
Important � Do not install the encoder and the decoder above an appliance which generates heat such a power amplifier. When installing the encoder and the decoder below a heat-generating appliance, install them below the appliance with a space equivalent to about 1 unit separating them. � Keep the temperature in the rack below +45 °C (113 °F). � When the rack is in a place subject to vibrations, fix the rear of the encoder and the decoder with reinforcing brackets (not included) � Fix the provided tapping screws into screw holes of the rack that have never been threaded before. When screwing a tapping screw into a threaded screw hole, thread ridge of the screw hole may be damaged.
Mounting the decoder
1. Remove the four rubber feet by removing the four screws from the bottom of the decoder.
2. Place the supplied rack mounting brackets on both sides of the decoder and tighten with the four supplied screws (M3x8).
Fixing screws (M3x8) (supplied)
Rubber feet
Top
3. Install the decoder with the rack mounting brackets in the rack by using four screws (not included).